FCS Fermentation Kits

Below you will find a kit based setup of FCS to make it easier for you.

The total price is the same as buying the parts separately.

If you prefer a modular configuration, have a look at the FCS Guide for Fermentation.
 

FCS Fermentation Starter Kit for Unitank

We've made a kit for those of you that don't want to make too many choices. This kit includes the recommended parts to get started with FCS.

- FCS Display Module and FCS I/O Module with power supply
- 1 temperature sensor (TC 1.5" 160mm)
- 1 pressure sensor with gas out solenoid
- All cables and adapters needed (3m length)

The kit does not include a valve/pump for cooling as these are tank dependent, and many of you already have a solenoid.

For non-Brewtools tanks, you also may need an adapter and/or tee to connect the spunding valve/pressure sensor assembly.

See guide below.

Accessories

To complete your FCS kit setup, some accessories are needed. 

- A solenoid for cooling (Ø4.5mm) with 2-pin LP12 cable and DIN43650 Type B adapter or a submersible pump (comes with cable). 

- A ball clamp and a connecting rod.

- An airlock for the pressure out solenoid valve is recommended. For smaller tanks we recommend our polycarbonate airlock. For larger tanks (300l+) you should use a TC34mm to 12mm barb and a 10x16mm silicone tube or equivalent.

- Tri Clamps and gaskets. Based on your tank and setup, you may need some extra tri clamps or gaskets.

- For MiniUni+, you need to replace the Mini Spunding valve with an M24 to Tri Clamp adapter and a 90 degree TC34mm elbow to fit your spunding assembly (if you want to use our TC air lock. No need for elbow if you use tubing as airlock). Rembember clamps/gaskets.

- If you don't have a Brewtools Unitank, we recommend getting TC 1.5" to 34mm adapter for the spunding setup. Tees/crosses are also available in all sizes to give you more ports.

For more choices, see the FCS Guide for Fermentation

More pipes, fittings and adapters can be found in the Valves and Fittings section.